Caselabs Sma8 Manual ❲360p❳

Many SMA8 cases were purchased with a pedestal—an additional modular base section. This pedestal is designed exclusively for massive liquid cooling setups. It can house another set of 480 or 560 radiators.

Used for general frame assembly and securing panels.

The basement of the SMA8 is specifically engineered to hold large radiators up to 480mm or 560mm in size. caselabs sma8 manual

Since CaseLabs is defunct, locating the original PDF is challenging, but the community has preserved the knowledge.

Small pliers or a 3/16" nut driver (for tightening motherboard standoffs) 2. Step-by-Step Frame Assembly Many SMA8 cases were purchased with a pedestal—an

The case supports dual PSUs. The PSU mounting bracket slides into the lower chamber. Install your power supply before finalizing the lower radiator mounts to ensure clearance.

Mount your power supply in the lower chamber using the rear PSU plate. If utilizing dual power supplies, remove the secondary blanking plate on the opposite side. Used for general frame assembly and securing panels

Drop the top radiator mount bracket out of the chassis by removing the retaining screws. Mount your fans and radiator to the bracket outside of the case, then slide the entire assembly back into the top roof slot and secure it. Bottom Chamber Radiator Mount

: Use the included nut driver to install drive cages (some are orientation-specific, marked with "F" for front or "T" for top).

Motherboard tray (removable), PCI-E bracket, lower radiator mounts, and front flex-bay brackets.