The capacity of the drive in Bay B (Target) must be equal to or greater than the capacity of the drive in Bay A (Source) . Any data on the target drive will be permanently overwritten. Execution Steps Insert the drive you want to copy into Bay A (Source) . Insert your destination drive into Bay B (Target) . Plug in the DC power adapter and turn the power switch ON .
Always turn off the device power switch before inserting or removing any drive to safeguard against data corruption caused by electrical arcs.
If installing a brand-new drive, you may need to format it via "Computer Management" > "Disk Management" before it can be used. 3. Verified Offline Clone Procedures (No PC Required)
Press the selector button on top to toggle control between Computer 1 and Computer 2. unitek yst03004 manual verified
[Source Drive: Slot A] =========> Sector-by-Sector Copy =========> [Target Drive: Slot B] (Must contain data) (Must be ≥ Slot A capacity) Critical Prerequisites Before Cloning:
Before diving into the manual, it is crucial to understand exactly what this device does. The Unitek YST03004 is a . It allows you to connect:
IDE drives require jumper settings. This is where a is most critical. The capacity of the drive in Bay B
If using a new, uninitialized drive, check "Disk Management" in Windows to initialize, partition, and format the drive.
Use the Up/Down buttons on the monitor to digitally enlarge the image further. Adjusting Illumination
: Supports simultaneous connection of two SATA drives (HDD, SSD, or SSHD) across SATA I, II, and III standards. Insert your destination drive into Bay B (Target)
Based on the model number , you are likely looking for the manual for the Unitek Y-Stand Series USB Charging Station (typically a 4-port or family-sized desktop charging station).
Insert your SATA HDD/SSD into the bays. The dock supports 2.5′′2.5 double prime 3.5′′3.5 double prime drives. Ensure the connectors are firmly aligned. Connection: Connect the USB 3.0 cable to your computer.