Remove the front cover screws from the shower unit and carefully lift off the cover. Disconnect any ribbon cables linking the cover controls to the internal PCB.
Is this a or a replacement of an older shower unit?
Properly flushing the system clears out manufacturing residue and activates the filtration media. Keep the downstream faucet open.
Turn the temperature control knob completely to the position.
: If the unit stops heating, the thermal safety device may have tripped due to overheating (often caused by low flow or limescale). Locate and press the internal reset button. galaxy aqua premier installation manual
Secure the bracket to the wall. If mounting to drywall, use heavy-duty wall anchors. For wood studs, drive the mounting screws directly into the wood. 3. Assembling the Ports
Select a position on the wall where the shower unit will sit comfortably within the cubicle or over the bath. Ensure the height accommodates all users in the household.
Thread the provided feed water adapter valve onto the shut-off valve using Teflon tape.
If you experience issues during or immediately after installation, refer to this diagnostic table. Probable Cause Corrective Action Mains water turned off; internal filter blocked. Remove the front cover screws from the shower
Electrical work must be carried out by a qualified person in accordance with local wiring regulations.
Thread the provided Feed Water Adapter Valve onto the cold water shut-off valve. Ensure the rubber O-ring is seated properly.
What or variation of the Premier system do you have?
To help me tailor any troubleshooting advice or technical specifications, please share the exact of your unit and if you are encountering a specific fault code or symptom . Share public link : If the unit stops heating, the thermal
Are you planning to connect the system to an ?
"Quick Start Guide" or "Installation Checklist"
Connect to a 230/240V supply via a double-pole switched fused connection unit (3 Amp for some auxiliary motors, but the main heater requires a dedicated high-amperage circuit). Ensure the unit is adequately earth bonded. HSD Online Commissioning (Initial Setup) Flush the System:
Turn off the electrical supply at the consumer unit and shut off the water mains.