Xtra Safe Kt 82001 Manual Jun 2026

Regardless of the specific model, your Xtra Safe likely includes:

Insert one of the keys, turn it counter-clockwise, and turn the master knob clockwise to open the door. 2. Installing the Batteries The digital keypad requires power to operate. Open the Safe: Ensure the door is open.

For further assistance, always consult the specific documentation that came with your unit, as manufacturer procedures can sometimes vary slightly by production run.

The safe features an internal voltage sensor. When battery power drops below an operational threshold:

Open the door to find the pre-drilled holes in the back of the case. Hold the box against the wall and mark the hole locations with a pencil. Xtra Safe Kt 82001 Manual

If the code is correct but the motor sounds "weak," the batteries likely need replacing. Money Stuck:

| Issue | Likely Cause | Solution | | :--- | :--- | :--- | | | Surface was dirty or not dry. | Clean surface; re-apply using new 3M tape or use screws. | | Gun slides down | Gun finish is too smooth/slick. | Ensure the rubber coating on the magnet is clean. | | Hard to remove gun | Magnetic pull is too strong. | Practice the "tilt and peel" motion rather than pulling straight off. |

🚨 Never lock your emergency override keys inside the safe. If the batteries die and the keys are inside, you will be locked out permanently. 🔋 Battery Installation

Disclaimer: This manual is based on standard operational procedures for the Xtra Safe KT 82001 series. Slight variations may exist depending on the production batch. Always consult the specific documentation included with your purchase. Regardless of the specific model, your Xtra Safe

Are you having trouble with the or the coin slot counter ?

Remove the small cover plate (usually between the keypad and the handle). Insert the override key into the keyhole.

Position the lockbox against the desired wall surface. Use a spirit level to ensure it sits straight.

The manual for the Xtra Safe Kt 82001 would typically start with an introduction, providing an overview of the product. This section would include: Open the Safe: Ensure the door is open

Check the face of the lock cylinder or your original manual for a stamped serial number. Some locksmiths or manufacturers can cut a replacement key using this code. Never drill the lock unless absolutely necessary, as this permanently ruins the safe's security integrity. 8. Summary of Quick Commands Steps to Take Indicator Signal Open with Code Enter Digits + Confirm ( A / B / # ) Green Light On Enter Setup Mode Press Red Reset Button (Inside Door) Yellow Light On Save New Code Enter New Digits + Confirm Key Double Beep / Light Off Low Battery Alert Attempt to open normally Red & Green Lights Together

(Typical for KT 82001)

Position the safe in your chosen spot. Open the door and use a pencil to mark the drilling points through the pre-drilled holes onto the wall or floor.