Huawei Flash Tools Idt 20 Jun 2026

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

: Required for your PC to communicate with the device in its low-level boot state. Board Software

Install the Huawei USB drivers on a Windows PC (Windows 10 is recommended). Disable Driver Signature Enforcement if the drivers fail to initialize.

IDT is not for the casual user. It is the "emergency scalpel" for when your Huawei phone or modem is a brick — no fastboot, no recovery, no life signs. Use it correctly, or you may permanently blow eFuses.

While holding the short, connect the phone to the PC using a reliable USB cable. huawei flash tools idt 20

Before attempting to use IDT v2.0, you must gather specific hardware and software components. Missing any of these steps will prevent the tool from communicating with your device. 1. Hardware Requirements

| Error Message | Probable Cause | Solution | | :--- | :--- | :--- | | | Missing drivers or wrong COM port | Reinstall Huawei EDL drivers; check Device Manager for "Ports." | | "Sahara protocol error" | USB cable issue or power drop | Use original cable; plug directly into motherboard USB port. | | "Hash mismatch (firehose)" | Corrupted firmware or wrong version | Download the correct firmware (CUST, BASE, or Preload package). | | "Permission denied: partition xbl" | Anti-rollback (ARB) protection | Downgrade not allowed. Flash an equal or higher version firmware. | | "Time out: reset device" | Battery voltage too low | Keep battery >30% or use a charger connected to the board. |

For years, Huawei smartphones have been a paradox for repair technicians and power users. On one hand, they offer premium hardware and impressive cameras. On the other, Huawei has aggressively locked down its bootloaders and restricted access to fastboot commands. Traditional tools like SP Flash Tool (for MediaTek) or Qualcomm’s QPST often fail with Huawei’s proprietary bootrom protocols.

Entering COM 1.0 mode usually requires opening the phone and shorting a specific "Test Point" on the motherboard to the ground while plugging in the USB cable. Step-by-Step Guide to Using Huawei IDT v2.0 Step 1: Install Drivers and Extract Files This public link is valid for 7 days

Disclaimer: This procedure is intended for advanced technicians. Mishandling hardware test points or flashing incorrect board files can permanently destroy device hardware. Step 1: Preparing the Software and Drivers

: Install the latest USB COM drivers so your PC can "see" the phone in its low-level state. Test Point Knowledge

The device should now naturally boot into a functional Fastboot mode instead of a dead black screen.

Click the button (often represented by a green play arrow) on the main interface. Can’t copy the link right now

Using IDT 2.0 is a technical process typically reserved for repair professionals:

The Huawei Flash Tools IDT 2.0 is a highly specialized and powerful utility for Kirin-powered devices. It is the primary tool for advanced users and repair technicians to recover devices that are otherwise considered completely dead. However, its immense power comes with significant risks and a steep learning curve.

: You must open the back cover of the phone to locate the hardware test points. Shorting these points forces the Kirin processor into its low-level bootloader interface.

For devices running (Kirin 9000/9010), you may experience: