Narishige Pc10 Manual New ((link)) Jun 2026
Single-stage pull (for large tips/microinjection) or dual-stage pull (for patch clamping and fine tips). 2. Unboxing and Installation Protocol
| Problem | Probable Cause | Remedy | | :--- | :--- | :--- | | Even if power is on, "HEATER LEVEL" does not display. | AC Power Cord is disconnected; voltage setting is incorrect; fuse is blown. | Plug cord in firmly; make correct voltage setting; check and replace fuse. | | Heater value is the same, but the pipette is different. | Heating Element is deteriorated. | Increase the heater value to compensate for loss of heat generation. | | Pipette looks distorted and off-center. | Glass capillary is not centered in the Heating Element. | Be sure the glass capillary is placed right at the center of the Heating Element. | | Heating function is inconsistent. | Heater Unit is affected by wind from AC, room temperature, and humidity. | Please place the instrument to avoid those factors as much as possible. | | The heating function is inconsistent and coils are touching. | The coils of Heating Element are in contact. | Use a wrench to separate them, or replace it with a new unit of PC-10H. |
The Narishige PC-10 isn’t just a puller; it’s a time capsule of mechanical genius. Before digital touchscreens and software updates, the PC-10 used gravity, a magnetic solenoid, and a carefully calibrated heater to pull glass capillaries into fine-tipped micropipettes. No firmware crashes. No DRM. Just physics and skill.
Center the glass capillary so the heater coil is positioned exactly at the midpoint of the tube. narishige pc10 manual new
Rotate the bottom switch 90 degrees counterclockwise to the "under weight" position (if applicable to your version). Press the red Start Switch
The secondary heating phase triggers automatically, followed immediately by the final drop that breaks the glass into two identical pipettes. Carefully remove both pipettes from the clamps. 5. Parameter Optimization and Troubleshooting
Decrease the Magnet dial value and slightly lower the Heater 2 temperature. This allows the glass to separate cleanly without stretching into a fine hair. 6. Maintenance and Cleaning Protocol | AC Power Cord is disconnected; voltage setting
While a brand-new, original Narishige PC-10 manual may no longer be in print, the essential information it contained has not disappeared. The most reliable and current information resides in Narishige's official online FAQ and support resources. Supplemented by specifications from distributors, the collective wisdom of online research communities, and the similar PC-100 documentation, you can effectively access the "new" operating and troubleshooting information you need.
Controls the electrical current sent to the platinum coil during the first and second pull stages. Higher numbers increase the temperature.
Insert the filament leads into the terminal blocks, centering the loop perfectly around the vertical glass trajectory path. | Heating Element is deteriorated
Based on the information provided in the Narishige PC-10 manual, we recommend that users:
Place the unit away from air conditioning vents, windows, and heavy foot traffic. Drafts alter filament cooling times, causing inconsistent pipette shapes.
