Place the thermostat approximately 5 feet ( m) above the floor.
Raise the setpoint temperature above the current room temperature. Verify that the heating system activates. Check the registers to confirm warm air delivery. To assist you further, please let me know:
Always verify that the fan coil unit's electrical specifications match the thermostat requirements.
Carefully unpack the unit, checking for any damages or missing components. Report any issues immediately. 2. Choosing the Ideal Location carrier 33tbac01 installation manual top
After wiring, use the thermostat's manual override to cycle through Heat, Cool, and Fan to verify every stage is engaging correctly.
The is a BACnet Communication Card designed to integrate Carrier commercial HVAC units into a Building Automation System (BAS) using the BACnet MS/TP protocol.
Once wired, snap the thermostat front cover onto the subbase and restore system power. You must configure the internal software settings for your specific HVAC setup. Entering Configuration Mode Place the thermostat approximately 5 feet ( m)
Note: The 33TBAC01 uses a 230V connection for both the motor and the valve. Step 3: Setting the DIP Switches
Controls 3-speed AC motors (~230V / 50Hz).
Locate the security locking screw on the top-left edge of the thermostat housing. Back out the screw fully to separate the front faceplate module from the wall-mounting base plate. Check the registers to confirm warm air delivery
Turn the selector knob towards the symbol to lower the temperature down to a minimum of 10°C (50°F). Turn it towards the (+) symbol to raise the temperature up to a maximum of 30°C (86°F).
Pull the HVAC wires through the large central opening of the baseplate.
: Carefully align the card's pins with the header and press firmly to seat it.
Are you installing this for a or a conventional system? Do you have a "C" wire available?
Drill holes, insert the wall anchors, and secure the baseplate firmly with the provided screws. Step 3: Wire the Thermostat Terminal Block