Follow these precise steps to safely charge your vehicle battery. Step 1: Inspect the Battery
: Connect clamps before plugging the charger into the AC outlet.
Arthur patted the dashboard of the truck, then looked over at the Bradex BX60 sitting on the workbench. He walked over and picked up the flimsy, yellowed manual. He wouldn't toss it back in the box. He grabbed a roll of tape, stuck the manual to the inside of the garage cabinet door, and patted the heavy metal charger.
If possible, remove the battery from the vehicle to avoid damage to vehicle electronics. bradex bx60 battery charger manual full
This is normal during "Engine Start" or high-amp charging. However, if it smells like burning plastic, unplug it immediately. Maintenance and Storage
Connect the clamp to the positive terminal of the battery.
Connect the clamp to a heavy, unpainted metal part of the engine block or chassis (away from the battery). Follow these precise steps to safely charge your
: If the unit fails to power on, check the "flat" blade car-type fuse located on the base of the charger and replace it if necessary.
Arthur paused at that line. He read it three times. “A battery that reads 0.0V is not dead. It is something else.”
If your battery is deeply discharged (very low voltage), the BX60 may not immediately show signs of activity. It may enter a conditioning mode, applying a low current to raise the voltage slowly before beginning the bulk charge. He walked over and picked up the flimsy, yellowed manual
Never connect or disconnect the clamps while the charger is plugged into the wall. This prevents dangerous sparks.
Always operate the charger in a well-ventilated area.
Once the battery is fully charged (usually when the ammeter reads near zero), follow this reverse order: Unplug the AC power cord from the wall first. Remove the Black (-) clip from the battery. Remove the Red (+) clip from the battery. 🔍 Troubleshooting Tips