Reset Epson L380-l382-l383-l385-l485-l386 Adjustment Program __top__ 【2026 Edition】

: The program will show a progress bar. Once finished, a message will prompt you to turn the printer off and then on again. After restarting, the flashing error lights should be gone.

Ensure the USB cable is securely connected and that you are not using a USB hub. "Printer not found": Restart the printer and the computer.

Are you seeing a specific like "Communication Error" while trying to run the resetter?

If you reset the printer multiple times without replacing or cleaning the pads, ink may eventually leak out of the bottom of the unit. Reset Epson L380-l382-l383-l385-l485-l386 Adjustment Program

This comprehensive guide will walk you through everything you need to know about resetting the waste ink pad counter for the Epson L380, L382, L383, L385, L386, and L485 printer models. Understanding the "Service Required" Error

Your antivirus has likely blocked the program. Re-download and add an exclusion to your antivirus for the program folder.

: In the new menu, select Waste ink pad counter and click OK . : The program will show a progress bar

Your printer's waste ink pad counter is now reset to 0%. 5. Important Considerations and Physical Maintenance

In the Waste Ink Pad Counter window, check the box next to (and Platen Pad Counter if available for your model).

When handling any internal components during pad cleaning or replacement: Ensure the USB cable is securely connected and

Do upload your printer EEPROM or share your adjustment program dump – each program may be tied to a specific firmware version.

A: Your antivirus software might be blocking the program. Try disabling it completely and running the program as an administrator.

and connected while using the software.

Open the back compartment of the printer, remove the plastic waste ink tray, wash the cotton pads thoroughly, and dry them before re-insertion.

: Allows for head ID settings, EEPROM initialization, and alignment adjustments. Pre-Step Requirements Before running the program, ensure the following: