Sinotimer Svp-916 Manual Pdf

Connect the Neutral wire leading to your load.

Understanding the technical limits of your Sinotimer SVP-916 ensures safe operation and prevents premature device failure. Specification Rated Voltage 230V AC (50Hz / 60Hz) Rated Current Options 40A or 63A (Model dependent) Over-voltage Protection Range 221V – 300V (Default: 280V) Under-voltage Protection Range 150V – 219V (Default: 160V) Over-current Protection Range 1A – 40A/63A (Default: 40A/63A) Power Recovery Delay Time 2 seconds – 512 seconds (Default: 60s) Power Consumption Electrical Machinery Life > 100,000 times Installation 35mm DIN Rail Wiring Diagram and Installation

Реле защиты от перенапряжения SVP-916 63A Sinotimer

To customize the parameters of the SVP-916, use the button to cycle through the internal programming menu. Follow these steps to adjust your parameters:

To enter the setting mode, press and hold the button for 3 seconds. Use the Up/Down arrows to adjust values. Function Description P01 Power-on Delay Time 1 – 500 seconds P02 Over-voltage Protection Value 221V – 300V – OFF P03 Over-voltage Recovery Value 220V – 299V P04 Over-voltage Protection Action Time 0.1s – 10s P05 Under-voltage Protection Value 150V – 219V – OFF P06 Under-voltage Recovery Value 151V – 220V P07 Under-voltage Protection Action Time 0.1s – 10s P08 Over-current Protection Value 1A – 63A/80A – OFF P09 Over-current Action Time 0.1s – 30s P10 Fault Recovery Delay Time 2s – 120s P11 Reset Mode AU (Auto) / HA (Manual) P12 Fault Inquiry (Last 5 records) UL (Under), UH (Over), IH (Current) P13 Finish and Exit Operational Notes Sinotimer Svp-916 Manual Pdf

The device simultaneously shows real-time Voltage and Current readings.

If set to HA (Manual Reset), you must manually clear the fault once conditions are safe. Error Indicator Codes

Below is a comprehensive overview of the product to help you understand its features and setup, all of which are detailed in the manual.

This table explains what each of the 13 parameters controls, providing a quick reference for programming your SVP-916. Connect the Neutral wire leading to your load

: The digital LED display flickered, showing the "under-voltage" status.

*Default current depends on the specific model (40A, 63A, or 80A).

Are you installing this for a (like a welder or large AC unit)?

Note: If no buttons are pressed for 10 seconds during configuration, the device will automatically save your changes and exit to the main monitoring screen. Safety and Operational Notes Follow these steps to adjust your parameters: To

| Symptom | Manual’s Solution (PDF reference) | |--------|-------------------------------------| | Display is blank | Check backup battery (CR2032) – replace if <2.8V (Page 6) | | Load doesn’t turn on | Verify “Auto” mode is lit, not “Manual” or “Off” (Page 7) | | Timer runs but wrong time | Re-set clock after power outage – unit loses time if backup battery dead (Page 4) | | “- - : - -“ on screen | Press reset; then reprogram (Page 4) |

Connect the Neutral wire leading to your household load/appliances to the terminal.

The primary advantage of the SVP-916 is its adjustability. To set the parameters, you will use the small buttons on the face of the device. Press and hold the Set button. Switch Menu Items: Press Set to toggle between parameters.

221V–300V (Default: 280V)

The grid voltage has fallen below your A5 value. It will restore power when voltage rises back to the A6 level.