Daikin Brc1c51 61 Installation Manual [2021]

. While it shares common Daikin installation practices, it has specific wiring and mounting requirements for integration with ventilation systems. Daikintech.co.uk 1. Pre-Installation Preparation Qualified Personnel

The remote controller screen will temporarily flash or display an initialization screen (often showing "88" or checking symbols).

The system will enter the Field Setting Mode, indicated by the "Mode No." flashing on the screen. Setting Main/Sub Controllers

: Use the provided wood screws to fix the back plate to the wall. Do not over-tighten, as a deformed plate can prevent the upper casing from snapping back on correctly.

However, I can provide the required for installation based on the technical data for this series. daikin brc1c51 61 installation manual

The BRC1C51/61 utilizes a simple, non-polar two-wire connection system, meaning you do not need to worry about reversing the positive and negative lines.

To set the time, hold the timer button for 5 seconds until the display blinks. Use the arrow buttons to adjust the minutes and day of the week, then confirm.

Relocate the unit away from drafts, direct sun, or heat-emitting walls.

Cut out the thin plastic knockout tab at the top of the casing using nippers. Step 3: Mounting the Lower Case Do not over-tighten, as a deformed plate can

Before beginning the physical installation, verify that the controller kit contains all original parts. If any components are compromised or missing, contact your authorized Daikin Comfort dealer immediately. Box Inventory

Connect the wires to terminals and P2 on the back of the remote controller board. Tighten the terminal screws securely.

Inside the box, you should find:

Daikin BRC1C51/61 is a wired remote controller specifically designed for VRV systems and Heat Reclaim Ventilation (HRV) units. Installing it correctly ensures precise climate control and access to advanced features like 24-hour programming and HRV integration. 1. Pre-Installation Safety and Requirements To set the time

With the mains isolation breaker turned completely , open the main electrical control box cover of your indoor unit to route the other end of the control wire. OPERATION MANUAL

The setting is confirmed only after all steps are completed; otherwise, it will exit after 5 seconds of inactivity.

Circuit board fault on the controller itself. Ensure no wires are pinched behind the plastic housing.